We don't have a way to look up the wheel studs your trailer would have so you'd have to measure what you have and get back to me.
The diameter and length of the wheel stud will be needed. Using a digital calipers like # PTW80157 can help you find these measurements.
I have attached a link that will take you to our page that has all of our wheel studs. When you find the correct size you need you can pick out what you will need from this page. view full answer...
The closest fitting replacement RV fireplace to replace your Greystone SF208-28 would be the Greysotne part # 324-000068 which has cut out dimensions of 26-1/4" wide x 20-1/2" tall x 5-3/8" deep. This would be a little smaller than what you have now but it would work. view full answer...
Yes, the Dexter Nev-R-Adjust Electric Trailer Brake Kit # 23-464-465 that you referenced fits the same 5 bolt mounting flange found on Lippert and Dexter 6k trailer axles.
This kit is for 7k axles though so you'd want the 6k kit part # 23-458-459 which also fits and is same dimensions. The difference between these two kit is the magnet sensitivity. While it might seem tempting to install brakes with a higher weight capacity it actually will make setting the brake controller up more difficult.... view full answer...
The replacement follow leg replacement you need is the Lippert # LC179013 which works and is interchangeable with Venture landing gear legs like you have and has the correct outer tube height of 29-1/2 inches. view full answer...
From Rep at PullRite, you will need to measure from the front edge of your king pin to the leading edge of the king pin plate to identify which you should use with your Rota-Flex 5th Wheel Pin Box and #LC328330.
See the attached image I provided with this, if that measures 5" then you need capture plate 331760. You can acquire this from PullRite. view full answer...
According to what Progressive Dynamics recommends, the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger # PD4560K18LS8 is the correct replacement for your WFCO WF-9960 converter that is compatible with lithium batteries like you have. view full answer...
Picking out springs for a trailer is based on basically two things. The axle capacity of the trailer and the length/width. Since you provided all of that info we can easily help you figure out what you need.
So dimensionally old springs tend to stretch a bit as they wear out so going with a spring that is slightly shorter than 25-1/4 inch would be what you'd need. For that the spring I'd recommend is the part # e54SR. This is a 6k spring that measures 25-1/8 inches in length, and is 1-3/4... view full answer...
Go To Results